Forum Entomologi Italiani
http://www.entomologiitaliani.net/public/forum/phpBB3/

Carcharodus alceae (Esper, 1780) - Hesperiidae Pyrginae
http://www.entomologiitaliani.net/public/forum/phpBB3/viewtopic.php?f=138&t=16460		 Pagina 1 di 1
Autore:  Salvatore Saitta [ 19/01/2011, 20:17 ]
Oggetto del messaggio:  Carcharodus alceae (Esper, 1780) - Hesperiidae Pyrginae
Non dovrebbero esserci dubbi :)

Carcharodus alceae (Esper, 1780)

348.jpg



348 inf.jpg



:hi:
Autore:  cosmln [ 19/01/2011, 20:29 ]
Oggetto del messaggio:  Re: Carcharodus alceae (Esper, 1780)
as an advice, hope that you don't mind.
when photographing ventral part of a butterflies you go very close to your background... and is hard to obtain a clean/shadow-less image. to obtain this I have build something like a cylinder in which I pin the butterfly. the butterflies will have in that way a big distance and the background will be like when photographing the dorsal part.
Autore:  Salvatore Saitta [ 19/01/2011, 20:38 ]
Oggetto del messaggio:  Re: Carcharodus alceae (Esper, 1780)
Yeah, thanks, I always accept advices, specially from a talented photographer like you :ok:
I hate to photograph the ventral side, and I usually didn't, and then I don't dedicate so much time :oops: If you can take a picture of your cylinder, and show that, it would be nice :)

Thanks again :hi:
Autore:  cosmln [ 02/02/2011, 19:31 ]
Oggetto del messaggio:  Re: Carcharodus alceae (Esper, 1780)
Salvatore Saitta ha scritto:
Yeah, thanks, I always accept advices, specially from a talented photographer like you :ok:
I hate to photograph the ventral side, and I usually didn't, and then I don't dedicate so much time :oops: If you can take a picture of your cylinder, and show that, it would be nice :)

Thanks again :hi:


here it is... made from plastatoze ( :?: not sure about the name) with a pin in middle for all the length... hope this helps you... now photos of Z.p. in preparation... and another one ;)

polyxena_stand.JPG
Autore:  clido [ 02/02/2011, 19:41 ]
Oggetto del messaggio:  Re: Carcharodus alceae (Esper, 1780) - Hesperiidae Pyrginae
cosmln ha scritto:
... made from plastatoze ( :?: not sure about the name) ...


I think, "plastozote"
Autore:  Salvatore Saitta [ 02/02/2011, 20:08 ]
Oggetto del messaggio:  Re: Carcharodus alceae (Esper, 1780) - Hesperiidae Pyrginae
Cool, thanks :ok:
I will try ;)

:hi:
Pagina 1 di 1 Tutti gli orari sono UTC + 1 ora [ ora legale ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/